W26.60-1018-11
Represented on gearbox 712.63
Adjust longitudinal support:
1 Release nut (2) on the longitudinal support (4) half a turn at most.
2 Twist nuts (2, 3) uniformly in a way that the adjustment device of the probe pin coincides centrally with the stick shift.
Meanwhile, the spherical terminal of the longitudinal support (4) must be parallel in regards to the stick shift (1).
3 Tighten nuts (2, 3) on the longitudinal support (4).
Adjust gear selection and coupling:
4 Release both nuts (5) at the rear gear selection and coupling support (7).
5 Turn screwed bar (6) from rear gear selection and coupling support (7) until the stick shift and the probe pin of the adjustment device are one on top of the other.
6 Align spherical terminals of the rear gear selection and coupling support (7) among them.
7 Tighten both nuts (5) at the rear gear selection and coupling support (7).
8 Activate stick shift several times on the gears directions. Verify adjustment again; correct if necessary.
To test, level regulating device probe pin up and release again. It should be possible to place probe pin in the center of the upper centralizing opening of the command lever.