AP82.10-D-8260A | Check and correct the adjustment of the headlamps | 27.5.11 |
MODEL 901, 902, 903, 904, 905
MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7
MODEL 900, 906
except CODE (LG0) Bi-xenon headlamps
except CODE (LG1) Bi-xenon headlamps with cornering illumination
MODEL 636, 639 except CODE (LG1) Bi-xenon headlamp with corner-illuminating fog lamps
D82.10-0006-01
1 Horizontal adjusting device
2 Vertical adjusting device
D82.10-0007-01
Course of light/dark border of low beam when reflector is aligned
Course of light/dark border of front fog lamp when reflector is aligned
D82.10-0008-01
| Checking | ||
1 | Drive vehicle to level surface | Vehicle must be in curb condition (curb weight, full fuel tank or corresponding additional weight). Driver seat loaded with 75 kg. | |
With model 639 with code (CLO) Rear lowerable/raisable air suspension, not in passive position | |||
2 | Check and correct tire inflation pressure | ||
3 | Align and adjust headlamp aimer as per the operating instructions | The reflector is aligned by turning the horizontal adjusting device (1) or vertical adjusting device (2). | |
Headlamp aimer - mobile gotis://E_82_01.0 | |||
4 | Place headlamp range adjustment switch on position 0 | ||
5 | Open engine hood | ||
6 | Check low beam setting and correct if necessary | ||
7 | Check setting of high beam | ||
8 | Check setting of front fog lamps and correct if necessary | Model 900, 906 with code (L16) Halogen front fog lamps, Model 636, 639 |