Failures checking via Stardiagnosis | |||
1 | Connect the diagnose equipment to the vehicle | Before starting the failures checking procedures, ascertain if the instrument cluster is the correct one for the vehicle. | |
The liberation protocol of the vehicle must be printed and attached in the QIS system together with PDI check list. | |||
2 | Turn on the ignition of the vehicle | ||
3 | Perform the quick test for failures identification | This procedure must be performed at least twice during the PDI inspection. Being once in the "Vehicle Reception" and again in the "Vehicle Release". | |
4 | Start the program "XENTRY Diagnostics" | ||
5 | Select the brand "Mercedes-Benz" | ||
6 | Select the option "Bus" | Select the option "Bus" and than, choose the vehicle family. | |
7 | Select "All Types" | After selecting "All Types", click on "Continue". | |
8 | Click on the stethoscope icon | ||
9 | Select "Quick Test" | Select " F3" to advance. | |
Some messages can be presented between performing one step and another. In this case, select "F2" to advance. | |||
Pay attention to the results " F - Current Failure " and " I - Stored failure ". | |||
If a question referring to the download of texts for instrument cluster updating is shown: | |||
| |||
Select "No" and advance with "F4". | |||
10 | Check a possible indication of active failure in the unit "MR Engine Control" | The active failure in the unit "MR Engine Control" cab be related to the SCR system / BlueTec5 still inactive (failure 16995). | |
If the correction of one or more failures depend on the re-parameterization of one or more electronic units: | |||
| |||
Consult the manual "ProParts". | |||
11 | Disconnect the diagnose equipment from the vehicle | No vehicle with one or more current failures or stored failures can be released and get the PDI stamp. |