D82.85-0022-06
1 Use oscillating saw to make cutout in the headliner (10).
Note pre-stamped marking on headliner (10).
The headliner (10) must not fray too much at the cutting edge because the cover will not have sufficient grip.
D82.85-0012-06
2 Clip cover (12) into cutout on headliner (10).
3 Insert assembly frame (DIN slot) (13).
4 Make cutout (13.2) up to third rib (13.1) in the assembly frame (DIN slot) (13).
The FleetBoard control unit wiring harness
is routed through the cutout (13.2).
D82.85-0008-11
5 Insert the FleetBoard control unit mounting frame (14) through cover (12) of the headliner (10).
Lock FleetBoard control unit mounting frame (14) by bending over the tabs.