P88.50-2436-06
1 Trunk lid
2 Damper
3 Security catch
4 Bolts
| Remove/install | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | |
1 | Open trunk lid (1) | ||
2 | Unhook damper (2) on left and right from trunk lid (1) at top | Detach lock tap (3) from damper (2). Mark installation position of trunk lid (1) | |
3 | Lay down trunk lid (1) | Do not close trunk lid (1). | |
4 | Unscrew bolts (4) from left and right hinge | | |
5 | Remove trunk lid (1) upwards | ||
6 | Install in the reverse order | ||
7 | Check gap dimensions on trunk lid, adjust if necessary | Gaps on hoods, doors and covers: | |
Type 452.4 | |||
Feeler gauge |
Test and adjustment values for gap dimensions
Number | Designation | Type | |||
BE60.00-P-1004-01J | Gap dimension | Liftgate/trunk lid to rear end center section | Dimension "C" | mm | 6,0 (2,0) |
Trunk lid to rear window crossmember | Dimension "M" | mm | 6,0 (1,0) | ||
Liftgate to roll bar | Dimension "Q" | mm | - | ||
Liftgate to side window | Dimension "R" | mm | - | ||
Trunk lid
Feeler gauge
129 589 03 21 00
Связанные документы
- ar6000p070001rr
- as0000z001101a Опасность получения травмы в результате защемления или зажатия пальцев при снятии, установке и регулировочных работах на капотах