ar8840p3200rt

Remove/install engine hood catch

Тип ar · тема 88.40 · версия 0100 · 2005-09-27

Применимость: MODEL 251

Нет на языке «ru»; показано на языке Английский.

Расположение

Функциональная группа 3 Кузов › 88 Оперение, навесные детали › 88.40 Капот — Серия 251

EinPAS 29 Система санкционированного доступа / система безопасности › 29.16 Блокировка / разблокировка › 29.16.32 Замок / привод — Серия 251

AR88.40-P-3200RT

Remove/install engine hood catch

6.6.05

MODEL 251

Remove/install engine hood catch

P88.40-2578-06

Shown on vehicle with engine 272

1 Engine hood

2 Bolts

3 Engine hood catch

4 Outer sleeve mounting

5 Hood lock release cable

6 Electrical connector

Remove/install

Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood (1)

AR88.40-P-1000RT

2

Undo screws (2) and remove engine hood catch (3) upwards

Left and right sides of the vehicle.

If necessary, route the cable in the area of the coupling to the left side of the vehicle.

*BA88.40-P-1003-01L

3

Unclip outer sleeve mounting (4) on the engine hood catch (3) downwards and unhook the engine hood cable (5)

Left and right sides of the vehicle.

4.1

Separate electrical connector (4)

Left side of vehicle only.

5

Install in the reverse order

Engine hood

Number

Designation

Model 251

BA88.40-P-1003-01L

Screw for engine hood lock on radiator crossmember

Nm

10

Связанные документы