AR86.30-D-0062EC | Remove/install water pump in fresh water tank | 17.3.05 |
MODEL 903.6 with CODE (ZL9) "James Cook" touring camper
D54.10-1109-08
1 Seat belts
2 Bench seat
3 Upholstery
4 Cover
D86.30-0153-08
9 Electrical connector
10 Cleaning cover
12 Electrical connector
13 Electrical wiring
B146/2 Fresh water fill level sensor
M77/1 Fresh water pump
14 Electrical line
15 Foam rubber pads
16 Fresh water tank
17 Hose
| Remove/install | ||
Danger! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Drain fresh water tank (16) | See Operator's Manual | |
2 | Disengage seat belts (1) from seat belt buckle | ||
3 | Move bench seat (2) toward front | ||
4 | Remove upholstery (3) | ||
5 | Fold out cover (4) | ||
6 | Disconnect electrical connector (9) | ||
7 | Remove cleaning cover (10) with fresh water fill level sensor (B146/2) | ||
8 | Separate electrical connector (12) | ||
9 | Unpin electrical lines (13) | ||
10 | Remove foam rubber pads (15) | Installation: Use new foam rubber pads (15). | |
11 | Install electrical line (14) with rubber grommet in fresh water tank (16) | ||
12 | Pull off hose (17) | ||
13 | Remove fresh water pump (M77/1) | ||
14 | Install in the reverse order | ||
15 | Check fresh water pump (M77/1) for proper function |
Связанные документы
- as0000z001101a Опасность получения травмы в результате защемления или зажатия пальцев при снятии, установке и регулировочных работах на капотах