AR82.35-S-6000C | Remove/install washer fluid reservoir of windshield washer system | 26.11.09 |
MODEL 638 with ENGINE 611, 111.950 /980, 104.900
S82.35-2502-06
1 Washer fluid reservoir upper section
2 Washer fluid reservoir lower section
3 Screw
4 Container for connectors
5 Cable tie
6 Water drain pipe
7 Washer fluid pumps
8 Nut
B43 Washer fluid level sensor
| Remove/install | ||
1 | Switch off ignition | ||
2 | Drain washer fluid | ||
3 | Unscrew bolt (3) | ||
4.1 | Remove washer fluid reservoir upper section (1) | Installation: Ensure that shackle is seated properly in splash wall. | |
Only with code F46 | |||
5 | Pull container for connectors (4) upward and unhook | ||
6 | Disconnect connector at washer fluid level sensor (B43) | ||
7 | Cut open cable tie (5) | ||
8 | Unclip water drain pipe (6) | ||
9 | Disconnect connectors at washer fluid pumps (7) | Installation: Do not mix up connectors. | |
10 | Remove washer fluid pumps (7) | Vehicles without code F46: Only 2 pumps present. | |
11 | Unscrew nut (8) | | |
12 | Remove washer fluid reservoir lower section (2) | Unclip hoses inserted in washer fluid reservoir. | |
13 | Install in the reverse order | ||
| Checking | ||
14 | Perform function test of washer fluid pumps (7) |
Windshield washer system