Adjust tilting/sliding roof cover

AR77.20-P-1100RT

Adjust tilting/sliding roof cover

28.10.04



Remove

 Danger!

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

When moving components, ensure that no body parts or limbs are within the operating range of moving parts.

AS00.00-Z-0011-01A

1

Remove rubber bellows (1)

AR77.20-P-1150RT

Adjust

2

Close tilting/sliding roof cover (4)

3

Open tilting/sliding roof cover (4) approx. 20 cm and then close again

4

Loosen bolts (2) on left and right on tilting/sliding roof cover (4)

5

Insert cardboard strips (3) at rear into expansion joint for tilting/sliding roof cover (4)

 Cardboard strip (3): approx. 500 mm long and approx. 2 mm thick

6

Adjust tilting/sliding roof cover (4) in relation to exterior roof surface

 Observe measuring position (A) for height adjustment.

Height setting

*BE77.20-P-1001-01F

7

Tighten bolts (2) on left and right on tilting/sliding roof cover (4)

 Tighten bolts (2) from rear to front.

8

Normalize tilting/sliding roof

 To normalize, move tilting/sliding roof to tilt position and hold switch down for 1s.

9

Check tilting/sliding roof for proper function and tilting/sliding roof cover (4) for proper seat



Install

10

Install tilting/sliding roof rubber bellows

AR77.20-P-1150RT

Number

Designation

Model 251

BE77.20-P-1001-01F

Height setting

Measuring position "A" (x)

mm

100

front: lower than outer skin of the roof

mm

1

rear: higher than outer skin of the roof

mm

1