Remove/install crank window in rear door

AR72.12-P-1910RT

Remove/install crank window in rear door

18.2.05

 

Remove/Install

1

Remove window guide rail (3) from rear door (2)

AR72.12-P-1911RT

2

Remove rubber seal (6) from front edge of rear door (2)

3

Unscrew bolts (5) and remove front window guide rail (7) from rear door (2)

4

Switch on ignition and roll crank window in rear door (8) down to 8 cm (A) from bottom edge of window frame by actuating corresponding switch in driver door

 The window should not chafe against the window frame, otherwise the glass and/or the paint on the window frame can be damaged.

5

Switch off ignition and remove transmitter key from EIS [EZS] control unit

 On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).

6

Remove rubber plug (4) and unscrew
bolt (9)



*BA72.12-P-1006-01L

7

Roll up rear door crank window (8) and lift out of window channel toward front

 The window should not chafe against the window frame, otherwise the glass and/or the paint on the window frame can be damaged.

 Installation: Completely press rear door crank window downward into mount

8

Install in the reverse order

Number

Designation

Model 251

BA72.12-P-1006-01L

Bolt, rear door crank window mount

Nm

7