P63.30-2283-05
1 Fit front side longitudinal member (1) and outer A-pillar (2) to body using vise grip pliers and C-clamps and fasten to straightening bench.
2 Tack weld front side longitudinal member (1) to body.
3 Remove outer A-pillar (2).
P63.30-2369-09
4 Front side longitudinal member (1) in illustrated areas .
5 Drill through Ø 4 mm bores in areas A and D on front side longitudinal member (1).
6 Countersink holes with 8 mm bit.
Countersink alternately from inside and outside
Areas not accessible from both sides can also be countersunk continuously on one side.
7 Front side longitudinal member (1) In areas A to F .
Complete other spot welds required in combination with body parts still exposed.
8 Grind down all spot welds flat if required.
9 Clean all other spot welds with wire brush