Commercially available tools
Workshop equipment
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1002-03A | Straight grinder (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
L61.25-0045-01
1 Measure distance a between corner pillar paneling (7) and center of console (6).
L61.25-0046-01
2 Mark contour (12) of removed longitudinal member on new longitudinal member.
3 Cut off new longitudinal member along marked contour (12).
L61.25-0047-06
3 Punch 6 mm dia. holes (14 - 17) at the ends of the longitudinal member.
4 Mark holes to be drilled (13) with the following dimensions:
Dimensions: a = Dimension measured between corner pillar paneling and console center
b = 30 mm
5 Center punch marked holes (13)
6 Drill center punched holes (13) with
5 mm dia. bit.
L61.25-0048-06
7 Mark holes to be drilled (18) on rear
of longitudinal member with the following dimensions:
Dimensions: c = 60 mm
d= 10 mm
8 Center punch marked holes (18).
9 Drill center punched holes (18) with
6 mm dia. bit.
10 Grind longitudinal member down to bare metal in area of all punched and drilled holes on both sides.
11 Grind longitudinal member down to bare metal in areas (19 and 20).
12 Coat bright sheet metal areas with zinc dust paint.