Workshop equipment
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
D63.20-0003-09
1 Mark cutting line (6) with length d = approx. 355 mm, at interval e = approx. 255 mm from edge (arrow) on inner part of A-pillar
(1).
2 Mark cutting line (7) at extension of cutting line (6).
3 Mark contours (arrows) on inner part of A-pillar (1).
4 Mark cutting line (8) at angle of 90° to cutting line (6) and at interval f = approx. 15 mm from marked sheet metal contours (arrows) on body.
5 Cut off inner part of A-pillar (1) along cutting lines (6, 7 and 8).
D63.20-0004-06
6 Punch holes in area (C) at uniform intervals of 40 mm and
6 mm.
7 Mark cutting lines (9) with length of g=20 mm in round parts of section of A-pillar inner part (2).
8 Cut section (2) along cutting lines (9) with cutting width of approx. 2 mm.
9 Taper shaded area (D) until it can be inserted below the wheelhouse on the body.
10 Grind section (2) down to bare metal on both sides in area of holes punched and coat with zinc dust paint
11 Grind section (2) down to bare metal in area (D) and coat with zinc dust paint.