Commercially available tools
Workshop equipment
WE58.40-Z-1001-02A | Inert gas welder |
WE58.40-Z-1002-02A | Spot welder |
WE58.40-Z-1003-02A | Multifunction device |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
D63.10-0022-12
1 Weld right side wall paneling (1) to drip molding (6) ( , arrows).
2 Weld right side wall paneling (1) to corner pillar paneling (5) and front paneling (14) ( , arrows).
D63.10-1145-12
To prevent the sheet metal parts from distorting, hold steel or copper block to side wall paneling from outside. The block (approx. 25mm x 25 mm x 200 mm) should make full contact.
3 Weld right side wall paneling (1) at bottom to inner section of side wall (10) ( , arrows).
4 Tack right side wall paneling (1) on window cutout of inner section of side wall (10) , arrows).
D63.10-1146-12
5 Cut out window cutout of side wall along inner section of side wall (dotted line).
6 Deburr cutting edge.
D63.10-1147-12
To prevent the sheet metal parts from distorting, hold steel or copper block to side wall paneling from outside. The block (approx. 25mm x 25 mm x 200 mm) should make full contact.
7 Weld right side wall paneling (1) to inner section of side wall (10) ( , arrows).
D63.10-0014-01
8 Weld right side wall paneling (1) to front inner side wall section and wheelhouse
( , arrows).
D63.10-0015-01
9 Weld right side wall paneling (1) to rear inner side wall section and wheelhouse ( , arrows).