Workshop equipment
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1003-03A | Angle grinder (electric/pneumatic) |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1001-07A | Zinc dust paint suitable for spot welding | A 000 986 34 42 |
D61.10-0024-09
1 Drill holes at a length of a = 460 mm with a maximum hole interval of 40 mm and 10 mm in area (6).
2 Drill holes at maximum hole interval of 40 mm and 10 mm in area (7).
3 Drill holes at a distance of b = 10 mm measured from top edge with a maximum hole interval of 40 mm and 10 mm.
4 Grind off areas (6, 7 and 8) on both sides and coat with zinc dust paint.
5 Grind off areas (9 and 10) and coat with zinc dust paint.
D61.10-0025-06
6 Mark auxiliary lines on both sides
of front frame longitudinal member (1) at a distance of c=20 mm and d=80 mm measured from bottom edge.
7 Drill five 10 mm holes at a width
of e = 210 mm.
The first hole at a distance of
f=10 mm measured from outer edge.
The remaining 4 holes at a distance of g = 50 mm measured from center of hole.
8 Cut four 10 mm holes at a width of h=175 mm.
The first hole at a distance of
i=10 mm measure from outer edge.
The remaining 4 holes at a distance
of j = 55 mm measured from center of hole.
D61.10-0036-05
9 Mark auxiliary lines on bottom side of front frame longitudinal member (1) at a distance of k=15 mm measured from outer edge.
10 Drill eight 10 mm holes at a width of I = 155 mm.
The first 2 holes at a distance of m=20 mm measured from the outer edge.
The remaining 6 holes at a distance of n = 45 mm measured from center of hole.
11 Cut two 10 mm holes at a distance of o=45 mm measured from the edge (arrow).