Replace tires

AR40.10-P-1030FF

Replace tires

21.8.07

Detaching



Information on tires / rims

AH40.10-P-9411-01A

1

Unscrew valve element from valve (1) and remove wheel balance weights (2)

2

Position bead breaker shovel of tire mounting device on the tire bead

3

Pry inside and outside of tire over the safety bead seats of the disk wheel

4

Clamp disc wheel on the tire mounting device

5

Align mounting head at a small distance (X, Y) to the disk wheel and fix in position

6

Position disk wheel so that valve (1) is approx. 10 cm in front of mounting head looking in the direction of rotation

7

Using an assembly lever, lever the tire bead over the assembly lug of the tire mounting device and pull off tire

8

Check condition of disk wheel

 If damaged, replace disk wheel.

9

Remove valve (1)

Attaching

10

Install new valve (1)

11

Coat inner and outer rim flange as well as both tire beads using tire assembly paste. Align mounting head of the tire mounting device at a small distance (X, Y) to the disk wheel

 Only use tire mounting paste for mounting tires.

12

Put the tire on the disk wheel at an angle and pull on over the rim flange

 Observe the running direction on tires with specified running direction.

Put as little stress as possible on bead area.

13

Align match points of the tire and disk wheel with each other, remove disk wheel with tire from tire mounting device

14

Pump up tire without valve element to a maximum of 3 bar

 The tire must slide evenly over the safety hump of the disk wheel, if necessary coat the tire bead with tire assembly paste again.

15

Screw the valve element into the valve (1) and correct tire inflation pressure to the specified value

 See tire pressure note in the vehicle's fuel filler flap.

16

Balance wheel

AR40.10-P-1040FF