ar3320d145205a

Mount transverse control arm to front axle beam

Тип ar · тема 33.20 · версия 0111 · 2011-09-15

Применимость: MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG1) Engageable all-wheel drive MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG2) Permanent all-wheel drive MODEL 903.0 /4 /6, 904.0 /4 /6 with CODE (ZG3) Gear reduction for all-wheel drive

Нет на языке «ru»; показано на языке Английский.

Расположение

Функциональная группа 2 Ходовая часть › 33 Передний мост › 33.20 Направляющая система подвески колёс, ступица — Серия 903 (модели 0**, 4**, 6**) · Серия 904 (модели 0**, 4**, 6**)

EinPAS 17 Трансмиссия / мост › 17.50 Передний мост › 17.50.41 Поперечный рычаг / рычаг / стабилизатор — Серия 903 (модели 0**, 4**, 6**) · Серия 904 (модели 0**, 4**, 6**)

AR33.20-D-1452-05A

Mount transverse control arm to front axle beam

Wheel location, hub

Number

Designation

Model 903.0/4/6 and
model 904.0/4/6
with code
ZG1/ZG2/ZG3

BA33.20-N-1003-01F

Spring travel limiter stop to stop plate

Nm

25

BA33.20-N-1006-01F

Bolt, stop plate to transverse control arm

M10

Nm

60

M121,5

Stage 1

Nm

-

Stage 2

°

-

Mount transverse control arm to front axle beam

D33.20-0002-01

1 Coat rubber springs of wishbone (12) with oil.

2 Support wishbone (12) with jack.

3 Insert front wishbone arm into bearing bracket and fix with wishbone bolt (2).

Replace nut on wishbone screw joint, but do not tighten.

4 Lower jack under wishbone.

Mount transverse control arm to front axle beam

D33.20-0004-01

5 Insert rear transverse control arm into mounting console and fasten in place using transverse control arm bolt (12).

Replace nut on wishbone screw joint, but do not tighten.

Mount transverse control arm to front axle beam

D33.20-0058-01

6 Bolt stop plate (7) onto wishbone (12) .

7 Bolt stop for spring travel limiter (10) onto stop plate (7) .