Remove/install rpm sensor

Designation

Trans-mission 716.622/
662

Trans-mission 716.643

Trans-mission 716.623

BA26.60-N-1015-01A

Bolt, rpm sensor to transmission housing

Тип ar · тема 26.19 · версия 0201 · 2009-11-16

Применимость: TRANSMISSION 716.643 in MODEL 901.6, 902.6, 903.6, 904.6 TRANSMISSION 716.622 in MODEL 208.344 /444 with CODE (424) Sequentronic automated manual transmission (SEQ) TRANSMISSION 716.662 in MODEL 208.348 /448 with CODE (424) Sequentronic automated manual transmission (SEQ) TRANSMISSION 716.6 in MODEL 203, 209.342 /361 with CODE (424) Sequentronic automated manual transmission (SEQ)

Нет на языке «ru»; показано на языке Английский.

AR26.19-D-0023A

Remove/install rpm sensor

9.11.09

TRANSMISSION 716.643 in MODEL 901.6, 902.6, 903.6, 904.6

TRANSMISSION 716.622 in MODEL 208.344 /444 with CODE (424) Sequentronic automated manual transmission (SEQ)

TRANSMISSION 716.662 in MODEL 208.348 /448 with CODE (424) Sequentronic automated manual transmission (SEQ)

TRANSMISSION 716.6 in MODEL 203, 209.342 /361 with CODE (424) Sequentronic automated manual transmission (SEQ)

D26.60-1149-11

Shown on transmission 716.643

1 Electrical connector

2 Screw

3 Rpm sensor

4 O-ring

Modification notes

1.3.04

"Disconnect/connect battery ground line" removed

 	Remove/install
1	Release electrical connector (1) at bottom and detach
2	Unscrew bolt (2)	 Installation: re-tap thread in transmission housing and replace bolt (2).
			*BA26.60-N-1015-01A
3	Pull out rpm sensor (3)	 The O-ring (4) can remain stuck in the transmission housing when pulling out the rpm sensor (3).
		 Installation: Install new O-ring (4).
4	Install in the reverse order

 Shift mechanism