AR26.19-D-0022A | Remove/install turning angle sensors | 8.5.09 |
TRANSMISSION 716.643 in MODEL 901.6##, 902.6##, 903.6##, 904.6## ## up to 159192
D41.10-1101-01
1 Propeller shaft retaining bracket
2 Screw
D26.60-1148-01
3 Sensors connector
4 Bracket
5 Screw
6 Screw
7 Shift sensor
8 Gear sensor
D26.60-1107-01
| Removing | ||
1 | Shift gear into "N" position | ||
2 | Remove propeller shaft retaining bracket (1) | ||
3 | Remove engine crossmember at rear | ||
4 | Disconnect sensors connector (3) | Turn connector approx. 45° counterclockwise and detach from bracket (4). | |
5 | Remove right rear bolt (5) on sensor plate | ||
6 | Remove bolts (6) | ||
7 | Turn shift sensor (7) approx. 45° clockwise and remove | ||
8 | Turn gear sensor (8) approx 45° counterclockwise and remove | ||
| Install | ||
9 | Insert gear sensor (8) twisted approx. 90° counterclockwise, turn clockwise and screw on | Do not allow bolts to fall into transmission housing. | |
| |||
10 | Insert shift sensor (7) twisted approx. 45° clockwise, turn counterclockwise and screw on | | |
11 | Screw right rear bolt (5) on the sensor plate | | |
12 | Connect sensors connector (3) and install on bracket (4) | ||
13 | Install rear engine crossmember | ||
14 | Install propeller shaft safety bracket (1) | | |
15 | Initialize gears | WITH DAS |
Sensors
Number | Designation | Trans-mission | |
BA26.19-N-1003-01B | Bolt, turning angle sensor to sensor plate | Nm | 3 |
BA26.19-N-1004-01B | Bolt, sensor plate to transmission housing | Nm | 3 |
Propeller shaft