si4020p0005a

Service Information: Operation texts and work units for chassis alignment

Tip si · temă 40.20 · versiune 0100 · 2005-11-29

Valabil pentru: MODEL all

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 40 Roţi, geometria sistemului de rulare › 40.20 Geometria sistemului de rulare — Seria 900 (modele 9**) · Seria 902 (modele 9**) · Seria 904 (modele 918, 919, 924, 925, 938, 943, 957) · Seria 906 (modele 917, 918, 924, 953)

EinPAS 20 Sistem de rulare › 20.10 Geometria sistemului de rulare › 20.10.20 Diagnoză/Verificare/Măsurare/Reglare — Seria 900 (modele 9**) · Seria 902 (modele 9**) · Seria 904 (modele 918, 919, 924, 925, 938, 943, 957) · Seria 906 (modele 917, 918, 924, 953)

EinPAS 45 Date/Informaţie › 45.20 Informaţie/Măsuri › 45.20.20 Informaţie service — Seria 900 (modele 9**) · Seria 902 (modele 9**) · Seria 904 (modele 918, 919, 924, 925, 938, 943, 957) · Seria 906 (modele 917, 918, 924, 953)

Valabil și pentru motoare/cutii de viteze: 139 ***, 254 ***, 256 ***, 272 ***, 276 ***, 282 ***, 457 9**, 541 9**, 542 9**, 608 ***, 700 4**, 700 420, 700 421, 700 422, 700 423, 715 3**, 715 5**, 722 6**, 722 9**, 724 ***, 724 0**, 724 033, 724 044, 724 045, 724 1**, 724 103, 724 114, 724 115, 724 120, 725 ***, 725 0**, 725 035, 725 037, 725 038, 725 085, 725 1**, 739 390, 739 391, 739 395, 739 396, 739 397, 739 398, 739 399, 740 698, 743 3**, 743 4**, 743 498, 746 971, 924 9**, 924 910, 925 9**, 926 9**

SI40.20-P-0005A

Service Information: Operation texts and work units for chassis alignment

24.11.05

MODEL all

Operation no. of operation texts or standard texts and flat rates

Category

Op. no.

Operation text

P

406500

Carry out vehicle measurements

P

404064

Adjust front wheel toe-in (during vehicle measurements)

P

404403

Adjust rear wheel toe-in (during vehicle measurements)

In future a distinction will no longer be made between optical and electronic chassis alignment in the operation texts and work units.

The operation texts and work units are valid for both methods of measurement.

The operation numbers are a modular design as per basic measurements plus associated and additional operations for adjustment operations.

WIS literature, work units and including texts are adapted corresponding to the revised scope of work and are valid as of 28.11.2005.