si0708d0001a

Service information on control units of mixture formation

Tip si · temă 07.08 · versiune 0102 · 2005-03-18

Valabil pentru: ENGINE 602.98 in MODELS 901, 902, 903, 904

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 1 Motor › 07 Pregătirea amestecului › 07.08 Calculatoare — Seria 602 (modele 98*) · Seria 901 · Seria 902 · Seria 903 · Seria 904

EinPAS 15 Motor › 15.45 Management motor › 15.45.11 Calculator/Releu — Seria 602 (modele 98*) · Seria 901 · Seria 902 · Seria 903 · Seria 904

EinPAS 45 Date/Informaţie › 45.20 Informaţie/Măsuri › 45.20.20 Informaţie service — Seria 602 (modele 98*) · Seria 901 · Seria 902 · Seria 903 · Seria 904

SI07.08-D-0001A

Service information on control units of mixture formation

8.11.99

ENGINE 602.98 in MODELS 901, 902, 903, 904

Modification notes

8.11.99

Supersedes STIN 07.12D006 dated 13.1.98

Variant coding of the EDC control unit for engine 602.98.

When replacing the EDC control unit, always remember to enter the correct variant coding as per the Sprinter Diagnosis Manual.

Problems if this is not observed - example of ADR function:

If a variant coding for working speed control is set for a control unit, although this control unit does not have this data record, the electronics will run in an undefined memory and program area each time the ignition is switched on.

The program is therefore no longer reprogrammable and must be replaced.

When entering the variant coding, it is important to wait for the run-on period to end after the request from Star Diagnosis - ignition OFF - and to only switch on the ignition when Star Diagnosis requests to do so.