P88.80-2158-09
Shown on model 204.0
1 Longitudinal member paneling
2 Expansion clip
3 Expansion clip
7 Clip
8 Clips
9 Clips
4 Clip
5 Underbody paneling
6 Bracket
P88.80-2160-06
Shown on model 204.0
1 Longitudinal member paneling
8 Clips
9 Clip
10 Mounting wedge
11 Front fender
| Removing | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four brackets at the lifting platform support points specified by the vehicle manufacturer. | |
1 | Raise vehicle with vehicle lift | ||
2 | Turn clips (4) 90° at bottom on longitudinal member panel (1) and remove | ||
3 | Remove expansion clip (3) at rear of longitudinal member panel (1) | ||
4 | Remove expansion clip (2) at front of longitudinal member panel (1) | ||
5 | Open front door, place suitable plastic pad between door bottom edge and longitudinal member panel (1) and mask with adhesive tape on door bottom edge. | The plastic pads prevent pressure marks on the longitudinal member panel (1). | |
6 | Guide longitudinal member panel (1) out of underfloor paneling (5) | ||
7 | Detach fender liner rear section from front fender (11) until clips (9) can be unclipped from the front fender (11). Then unclip clips (9) | Thereby pull longitudinal member panel (1) away from front fender (11) | |
Mounting wedge | |||
8 | Pivot longitudinal member panel (1) toward outside in area of longitudinal member at bottom, insert assembly wedge (10) at clips (8) from bottom and slide upward with uniform pressure. | Thereby pull longitudinal member panel (1) away from longitudinal member | |
Mounting wedge | |||
9 | Unclip longitudinal member panel (1) from rear fender | Mounting wedge | |
| Install | ||
10 | Remove clip (7) from rear fender and install at longitudinal member panel (1) | ||
11 | Clip in longitudinal member panel (1) | ||
12 | Guide longitudinal member panel (1) into underfloor paneling (5) | ||
13 | Clip clips (4) into bracket (6) at bottom of longitudinal member panel (1) | ||
14 | Install fender liner rear section on front fender (11) | ||
15 | Install expansion clips (2) at front of longitudinal member panel (1) | ||
16 | Install rear expansion clip (3) on longitudinal member panel (1) | ||
17 | Remove plastic pad and adhesive tape | ||
18 | Lower vehicle |
Mounting wedge
110 589 03 59 00
Documente menționate
- as0000z001001a Pericol de moarte prin alunecare sau basculare a autovehiculului de pe elevator