T88.20-0003-01
Shown on left side of vehicle
1 Bumper
2 Engine compartment encapsulation
3 Frames
4 Bracket
| Remove, Install | ||
1 | Open rear flap | ||
2 | Disconnect electrical connector for reversing light | To do this, unscrew the reversing light reflector. | |
3 | Pull cable out of reversing lamp housing | ||
4 | Disconnect electrical connector for rear fog lamp | To do this, unscrew the rear fog light reflector. | |
5 | Pull cable out of rear fog lamp housing | ||
6 | Disconnect electrical connector for the two license plate lamps | ||
7 | Pull cable out of the two license plate lamp housings | ||
8 | Release cable from brackets on rear bumper | ||
9 | Unscrew right and left brackets (4) for bumper (1) from frame (3) | ||
10 | Unscrew bumper (1) from engine compartment encapsulation (2) | ||
11 | Unscrew bumper (1) from both upper brackets on frame | The two brackets are located at the top of the bumper on the left and right sides. | |
12 | Remove the bumper (1) | ||
13 | Install in the reverse order |