ar8325p1000k

Removing and installing heater housing

Tip ar · temă 83.25 · versiune 0101 · 2004-10-21

Valabil pentru: MODEL 208

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 3 Suprastructură › 83 Climatizare › 83.25 Sistem automat de încălzire — Seria 208

EinPAS 39 Încălzire/Aerisire/Răcire › 39.15 Climatizare › 39.15.32 Carcasă/Schimbător de căldură/Vaporizator/Filtru — Seria 208

AR83.25-P-1000K

Removing and installing heater housing

19.3.97

MODEL 208

Removing and installing heater housing

P83.25-0399-09

1 Screw

2 Philips screw

3 Jacket tube

4 Transverse pipe

5 Nut

12 Cockpit separation point

13 Connector

W1 Main ground (behind instrument cluster)

W29/2 Ground, right A-pillar

6 Connector

7 Screw

8 Fixture

9 Screw

10 Nut

11 Heater housing

Removal, installation

Danger!

Risk of injury to skin and eyes from scalding with hot coolant which splashes out. Risk of poisoning from swallowing coolant.

Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage bottles.

Wear protective gloves, protective clothing and eye protection.

AS20.00-Z-0001-01A

1

Drain coolant

Installation: Pour in coolant.

AR20.00-P-1142HA

2

Remove water collector

AR83.25-P-1402K

3

Remove hot water feed and return hoses

Plug openings (parts kit).

4

Remove instrument panel

AR68.10-P-1000K

5

Remove passenger airbag

AR91.60-P-0680K

6

Remove insulating mat

N

Unscrew screws (1)

8

Remove main ground (W1)

9

Unscrew Philips screw (2) from cable duct

10

Unscrew nuts (arrow) and unhook jacket tube (3) off transverse pipe (4)

11

Unscrew nuts (5)

12

Pull off connector (6) on heater core temperature sensor

13

Unscrew screws (7) and remove holder (8)

14

Remove air ducts to side nozzles and rear air ducts on left and right

15

Expose electric wiring

Installation: Replace cable strapes

16

Remove ground, right A-pillar (W29/2)

17

Unscrew nut (10)

18

Unscrew left and right screws (9) on
A-pillar

19

Remove transverse pipe (4)

Avoid damaging passenger compartment.

20

Disconnect vacuum lines from cockpit separation point (12)

21

Pull off connector (13)

22

Remove heater housing (11)

23

Install in opposite order

Documente menționate