Removing and installing wiper motor

AR82.30-P-6800B

Removing and installing wiper motor

28.5.98



Removal

Danger!

Injury hazard Windshield wiper mechanism can pinch, crush or, in extreme cases, even sever extremities

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A

1

Withdraw ignition key

2

Remove cover on air intake

ra83001240140x

3

Remove cover (11)

4

Remove hose from side cover (11)

5

Move wiper system to maximum extension

6

Remove wiper arm

 Pull plastic cover (1) downward, unscrew screw (2) and remove wiper arm.

N

Unscrew nuts (3)

8

Unscrew screws (4)

9

Open cable strap (5)

10

Press connector off relay (K26)

 Remove connection and disconnection aid and move input (E) in connector frame.

11

Remove wiper motor with gear

 Slide wiring harness with rubber grommet through firewall and remove wiper motor with gear.

12

Remove nut (6) and press off crank arm (7)

13

Remove screws (8) and wiper motor



Installation

14

Move wiper motor to park position

 For this purpose connect wiper motor to wiring harness and actuate combination switch once with ignition switched ON until wiper motor is in park position.

15

Install wiper motor on linkage



*BA82.30-P-1001-01E

16

Install crank arm on wiper motor shaft



 Position crank arm on wiper motor shaft and install nut (6). Linkage (A) must be positioned vertically over center of wiper motor shaft.

*BA82.30-P-1002-01E

17

Install wiper motor wiring harness

 Slide wiring harness with rubber grommet through firewall, route and fasten with cable strap (5).

18

Press connector onto relay (K26)

 Complete connection and disconnection aid.

19

Install wiper motor

 Position wiper motor, tighten nuts (3) only slightly and screw in screws (4).

20

Adjust distance between wiper gear head and windshield

Adjust distance A only.

AR82.30-P-6400-01A

*BE82.30-P-1001-01A



*129589032100

21

Tighten nuts (3)

22

Install wiper arm and screw in screw (2)

23

Install plastic cover (1)

 Press plastic cover upward until it catches.

24

Move wiper arm to center position

25

Adjust distance between wiper arm and wiper blade

Adjust distance B only.

AR82.30-P-6400-01A

*BE82.30-P-1002-01A



*129589032100

26

Install cover on air inlet

ra83001240140x

Number

Designation

Model 129

BE82.30-P-1001-01A

Dimension

Distance" A" between wiper gear head and windshield

mm

5

See figure

AR82.30-P-6400-01A

BE82.30-P-1002-01A

Dimension

Distance "B" between wiper arm and wiper blade

mm

5

See figure

AR82.30-P-6400-01A

Number

Designation

Model 129

BA82.30-P-1001-01E

Screw on wiper motor

Nm

5

BA82.30-P-1002-01E

Nut on wiper motor shaft

Nm

19