ar8230p6400rt

Remove/install wiper system

Tip ar · temă 82.30 · versiune 0100 · 2005-06-23

Valabil pentru: MODEL 251

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 3 Suprastructură › 82 Instalaţie electrică, structură › 82.30 Ştergător parbriz — Seria 251

EinPAS 36 Vizibilitate › 36.30 Ştergere/Spălare › 36.30.50 Instalație de spălat parbrizul — Seria 251

AR82.30-P-6400RT

Remove/install wiper system

2.2.05

MODEL 251

Remove/install wiper system

P82.30-2515-09

1 Wiper system

2 Mounting screws

3 Bolt

M6/1 Wiper motor

4 Bolt

5 Wiper system bracket

6 Electrical connector

Remove/install wiper system

P82.30-2516-04

1 Wiper system

7 Wiper linkage

8 Wiper motor crank

9 Bolts

Remove/install

Danger!

Risk of injury in the form of trapping or crushing, or even severing of limbs, if caught in windshield wiper mechanism

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A

1

Move the wiper arms into park position and switch off the wiper system (1)

2

Switch off ignition and remove transmitter key from EIS control unit

The wiper system (1) may switch on by itself when the ignition is on as a result of the rain sensor on the windshield.

On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).

3

Remove water repellent over wiper system

AR83.25-P-1406RT

4

Unscrew mounting screws (2) from wiper system (1)

*BA82.30-P-1004-01K

5

Remove screw (3)

Do not loosen bolt (4) from bracket on wiper system (5)

Do not change installation position of wiper system bracket (5) at partition wall, since this would change the contact pressure of the wiper arms and therefore the wiping area.

6

Lift wiper system (1) and disconnect electrical connector (6) from wiper motor (M6/1)

7

Remove wiper system (1)

8.1

Unclip wiper linkage (7) from engine crank (8).

When replacing wiper system (1).

9.1

Rotate the wiper motor crank (8) (M6/1) to the right until all the screws (9) are accessible

When replacing wiper system (1).

10.1

Unscrew bolts (9)

When replacing wiper system (1).

*BA82.30-P-1002-01K

11

Install in the reverse order

12

Carry out function check of the windshield wipers and the windshield washer system

Windshield wipers, windshield washer system and headlamp cleaning system - Function check

AP82.30-P-8252RT

Windshield wiper

Number

Designation

Model 251

BA82.30-P-1002-01K

Bolt on wiper motor

Nm

10

BA82.30-P-1004-01K

Bolt, windshield wiper frame to body

Nm

20

Documente menționate