ar8210p401101a

Checking vacuum system of headlamp range adjustment

Tip ar · temă 82.10 · versiune 0100 · 1999-01-11

Valabil pentru: MODEL 129

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 3 Suprastructură › 82 Instalaţie electrică, structură › 82.10 Sistem de iluminat exterior — Seria 129

EinPAS 30 Instalaţie de iluminat › 30.15 Sistem de iluminare exterior › 30.15.30 Reglare distanţă faruri — Seria 129

AR82.10-P-4011-01A

Checking vacuum system of headlamp range adjustment

Test values for exterior lighting

Number

Designation

Model 129

BE82.10-P-1001-01D

Pressure values for pneumatic headlamp range adjustment

Position 0

mbar

400 30

Position 1

mbar

290 30

Position 2

mbar

200 30

Position 3

mbar

50 30

Checking vacuum system of headlamp range adjustment

201 589 13 21 00

Vacuum tester

Checking vacuum system of headlamp range adjustment

P82.10-2144-01

1 The pressure for the headlamp range adjustment can be measured on the pressure valve block (4). The pressure valve block (4) is located in the right component compartment.

2 Allow engine to run.

3 Set headlamp range adjustment to individual positions and read off pressure values. If the nominal value is not reached, perform leakage test.

Checking vacuum system of headlamp range adjustment

P82.10-2145-01

If the connection sockets are leaky they can be replaced by adapters (8). For this purpose separate pneumatic line (9) from control switch (7) and shorten by 50 mm. Install adapter (8) instead of cut connection socket and connect to hose connector (approx. 40 mm long).