D82.10-1214-08
Shown on left front lamp unit (3) on model 907 with code LG7 (LED High Performance headlamp) |
1 | Electrical connector | 3 | Front lamp unit | 5 | Bolts | ||
2 | Engine hood cable | 4 | Radiator crossmember |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | Model 907, 910 | |
| Remove/install | ||
1 | Commission left or right front lamp unit (3) using vehicle diagnosis system. | Model 907, 910 | |
| |||
Installation: Note content of data matrix code located on left or right front lamp unit (3). | |||
2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
3 | Disconnect electrical connector (1). | ||
4 | Unclip hood cable (2) from front lamp unit (3) (arrow). | If the left front lamp unit (3) is removed. | |
5.1 | Remove front bumper in area of lamp unit (3). | If the left or right front lamp unit (3) is removed individually. | |
5.2 | Remove front bumper. | If the left and right front lamp unit (3) are removed together. | |
6 | Mark position of front lamp unit (3) relative to radiator crossmember (4). | ||
7 | Remove bolts (5) and take off front lamp unit (3). | Installation: Before tightening bolts (5), align front lamp unit (3) with markings. | |
8 | Install in the reverse order. | ||
| Check | ||
9 | Check and correct headlamp adjustment. | ||
10 | Attach retaining cap of setting screw for low beam height adjustment. | Model 907 | |
Retaining cap |
Documente menționate
- ad0000d200006ts
- ah5400p000101a Indicaţii pentru evitarea defectării componentelor electronice prin descărcare electrostatică
- ar8210d1131ts
- ar8820d2000ts