S72.29-4539-09
Shown on removed sliding door |
1 | Cable tie | 3 | Retaining clips | B51/8 | Left sliding door front edge obstruction sensor | ||
2 | Electrical connector | B51/7 | Right sliding door front edge obstruction sensor |
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Remove door trim of respective sliding door | ||
2 | Remove sliding door trim | ||
3 | Detach cable tie (1) and disconnect electrical connector (2) | Installation: Replace cable tie (1). | |
4 | Remove retaining clips (3) and remove right front edge on sliding door anti-pinch protection (B51/7) or left front edge of sliding door anti-pinch protection (B51/8) | Installation: Guide electrical wiring harness on right front edge on sliding door anti-pinch protection (B51/7) or left front edge of sliding door anti-pinch protection (B51/8) through opening in sliding door. | |
5 | Install in the reverse order | ||
| Check | ||
6 | Check anti-pinch protection of sliding door for proper function |
Documente menționate
- ar7216s6610e
- as0000z001101a Pericol de rănire prin prinderea sau strivirea degetelor la operaţii de demontare, montare şi reglare la capote, uşi, capace şi tavan culisant