P72.10-0019-06
1 Window crank
2 Round lock cover
3 Handle recess
4 Philips screw
5 Door liner
P72.10-0008-01
P72.10-0005-01
6 Screws
7 Retainer
8 Linkage
P72.10-0002-01
P72.10-0001-01
| Removal, installation | ||
1 | Open crank window | Rear door open | |
2 | Remove window crank | ||
3 | Unscrew screw on round lock cover (2) and remove round lock cover downward. | ||
4 | Press handle recess (3) off with installation wedge | | |
5 | Unscrew screw (6) in area of inner door actuation | ||
6 | Unscrew Phillips screw (4) on armrest | ||
7 | Press door liner (5) off of inner door panel at bottom, front and rear with installation wedge | Insert installation wedge directly next to each clip. | |
8 | Lift door liner (5) at top on sealing rail up out of clips with installation wedge and simultaneously pull away from inner door panel | | |
9 | Open retainer (7) on linkage (8) for door interior actuating mechanism and detach linkage (8) | ||
10 | Disconnect electrical connections on door liner | ||
11 | Put down door liner | ||
12 | Check foil and clips on inner door panel | Replace damaged foil or clips. Rivet on support for armrest mount after installing foil. When replacing foil cut out this area and glue with overlap joint or seal with adhesive strap. | |
13 | Check clips on door liner | Replace damaged clips | |
14 | Install in reverse order |
Special tool
110 589 03 59 00
Installation wedge