Remove/install paneling on rear pillar

AR68.30-P-4505GL

Remove/install paneling on rear pillar

28.11.2018

Model

461.238/239/332/333/334/335/336/337/338/450

Shown with a wheelbase of 2,850 mm

1

Pin

5

Rear pillar trim

2

Expansion rivet

6

Electrical connector

3

Trim strip

7

Retaining bracket

4

Trim strip

8

Fold

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

 

Remove/install

1

Remove grab handle.

When removing the right rear pillar panel (5).

2

Remove expansion rivets (2) from rear pillar panel (5).

 Pull pins (1) out of expansion rivets (2).

 Mounting wedge

*110589035900

3

Remove trim strip (3).

4

Remove trim strip (4).

5

Remove rear pillar panel (5).

 Ensure that the rear pillar panel (5) does not tear when pulling it out.

 Installation: Ensure that the side window seal is seated above the rear pillar panel (5).

 Mounting wedge

*110589035900

6

Pull rear pillar panel (5) forward until electrical connector (6) is accessible.

If rear speakers are installed.

7

Release and disconnect electrical connector (6).

If rear speakers are installed.

8

Remove rear pillar panel (5).

 Installation: Ensure that the retaining bracket (7) of the rear pillar panel (5) is behind the fold (8).

 Mounting wedge

*110589035900

9

Install in the reverse order.