ar6830p4495f

Removing and installing trim panel at D-pillar

Tip ar · temă 68.30 · versiune 0101 · 2010-01-19

Valabil pentru: MODEL 210.2

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 3 Suprastructură › 68 Echipament interior › 68.30 Capitonaje, ramă ornament — Seria 210 (modele 2**)

EinPAS 37 Echipament interior › 37.45 Capitonaj › 37.45.30 Capitonaj habitaclu/Habitaclu — Seria 210 (modele 2**)

AR68.30-P-4495F

Removing and installing trim panel at D-pillar

18.1.10

MODEL 210.2

Removing and installing trim panel at D-pillar

P68.30-2142-06

1 Paneling

2 Guide rail

3 Screws

4 Cover

5 Nut

6 Clips

7 Electrical connector

8 Clip

 	Removal, installation
1.1	Open spare wheel cover and remove	 When removing left trim panel (1)
1.2	Open right stowage compartment cover and remove	 When removing right trim panel (1)
2	Remove rear load anchor
3	Remove guide rail (2) for retractable cover
4.1	Pull cover (4) off of paneling (1) and unscrew nut (5)	 Vehicles with window airbag (code 290)
			*BA91.60-P-1005-01A
5	Carefully unclip paneling (1) with long wedge and remove	 Position long wedge directly at clips (6)  Installation: Ensure that the lug (arrow) reaches correctly into the clip (8). Check clips (6) and (8) on window cutout, replace if necessary.
6	Disconnect electrical connector (7) from interior lamp
7	Install in opposite order	 Installation: Ensure that the lugs (arrows) reach correctly into the window cutout clips.

 Airbag

Number	Designation		Model 210


BA91.60-P-1005-01A	Nut for window airbag on roof frame	Nm	5