1 | Paneling on front soft |
2 | Soft top compartment lid |
3 | Rubber seal |
4 | Bolts |
P68.30-3844-06
Warning | Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts. | |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Warning | Risk of injury when performing check and repair work in area of roll bar | Keep body parts out of the area where the roll bars extend. | |
Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | |||
| Remove/install | ||
1 | Move soft top into intermediate position and secure | ||
2 | Remove left and right rubber seal (3) until bolts (4) are accessible | ||
3 | Unscrew left and right bolts (4) | ||
4 | Manually lay down soft top in soft top compartment | Helper required. | |
5 | Unclip paneling on soft top (1) from soft top compartment | Installation: Check mounting clips for damage and replace if required. | |
6 | Pull out paneling on soft top (1) below rubber seal (3) and remove | ||
7 | Install in the reverse order |
Documente menționate
- ah9100z000010a Indicaţii, evaluări şi dispoziţii legale referitoare la lucrări, manevrarea şi depozitarea de componente pirotehnice
- ar7730p103001lca
- as0000z001101a Pericol de rănire prin prinderea sau strivirea degetelor la operaţii de demontare, montare şi reglare la capote, uşi, capace şi tavan culisant
- as9100z000301lca Pericol de rănire în zona rollbar la lucrări de verificare şi reparaţie
- as9100z000801a Pericol de rănire la lucrări de verificare şi reparaţie în legătură cu componente pirotehnice