P63.50-4080-09
The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
1 | Mark separating points on rear fender (1) and cut (areas A). |
Transfer separation points from vehicle. |
P63.50-4081-08
2 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
3 | Remove grinding dust. |
4 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (area D). |
Observe preliminary treatment of bonding surface. |
P63.50-4082-09
5 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
6 | Remove grinding dust. |
7 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surfaces with zinc dust paint (areas D). |
Observe pretreatment of bonding surfaces. |