Remove/install brake carrier with brake caliper

AR42.10-T-0600BA

6.9.11

MODEL NMB613.358 /388 with REAR AXLE 746.217

W42.10-1084-09

1 Bolt

2 Fitted bolt

6 Brake carrier with brake caliper

3 Combination cylinder

5 Sensor line plug

 	Remove/install
1	Remove wheel		AR40.10-T-1100B
2	Remove brake pads		AR42.10-T-0170BA
3	Detach sensor line connector (5) from brake caliper	 Only detach or plug on plug of sensor line (5) axially and carefully loosen or tighten the threaded connection as in the event of the plug connection or threaded connection becoming damaged the brake caliper must be replaced.
			*BA42.10-N-1002-12I
4	Remove combination cylinder (3)		AR42.10-T-0700BA
5	Remove brake carrier with brake caliper (6)	 Loosen fitted bolt (2) last.
		 Installation: Use new bolts (1). First screw in the fitted bolt (2) on the exit side of the brake disk finger-tight.
			*BA42.10-N-1001-07F
			*BA42.10-N-1002-07F
6	Clean contact surface on axle
7	Install in the reverse order

 Brake carrier

Number	Designation			Model 613.358/388 with RA 746.217 with disk brake


BA42.10-N-1001-07F	Bolt, brake carrier to axle/disk brake	M161,5	Nm	260
		–	Nm	–
BA42.10-N-1002-07F	Fitted bolt, brake carrier at axle/disk brake	M161,5	Nm	260

 Rear axle brake caliper

Number	Designation		Models 613.358/388 with rear axle 746.217


BA42.10-N-1002-12I	Bolt connecting brake wear sensor to brake caliper	Nm	1