ar4210b0130ta

Check bellows on thrust pieces

Tip ar · temă 42.10 · versiune 0205 · 2017-10-27

Valabil pentru: Model 934.241/251 with code BB5 (Disc brakes on front and rear axle) Model 958.2/4 with code BB5 (Disc brakes on front and rear axle)

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 42 Sistem hidraulic frâne şi sistem mecanic › 42.10 Frână de serviciu — Seria 934 (modele 241, 251) · Seria 958 (modele 2**, 4**)

EinPAS 21 Frâne/instalație vacuum/instalație de aer comprimat › 21.15 Frână de serviciu/instalație vacuum › 21.15.40 Frână de serviciu față — Seria 934 (modele 241, 251) · Seria 958 (modele 2**, 4**)

EinPAS 21 Frâne/instalație vacuum/instalație de aer comprimat › 21.15 Frână de serviciu/instalație vacuum › 21.15.42 Frână de serviciu spate — Seria 934 (modele 241, 251) · Seria 958 (modele 2**, 4**)

AR42.10-B-0130TA

Check bellows on thrust pieces

19.10.2017

Model

934.241/251

with code BB5 (Disc brakes on front and rear axle)

Model

958.2/4

with code BB5 (Disc brakes on front and rear axle)

Check bellows on thrust pieces

1

Pressure piece

2

Fanfold bellows

W42.10-0010-01

Remove

Danger

Risk of death caused by vehicle slipping or toppling off during lifting

Only lift vehicle at the lift support points specified by the vehicle manufacturer.

AS00.00-Z-0032-01A

Notes on repairing brake caliper

AH42.10-N-9406-05A

1

Remove the wheel


.

AR40.10-B-1100D

2

Remove the brake pads

AR42.10-B-0170TA

Check

3

Check the fanfold bellows (2) and the pressure parts (1)

In the case of malfunctioning of the pressure parts (1) and/or damages in the fanfold bellows (2):

Replace the pressure parts (1) with the fanfold bellows (2).

Remove/install thrust pieces with boots when brake caliper is installed

AR42.10-B-0200TA

Install

4

Install a new brake pad at the outer span of the brake carrier


The pad limits the adjustment travel of the pressure pieces (1) preventing the total output of threaded pipes.
This would result in the replacement of the brake caliper.

5

Adjust the regulator clockwise until the two fanfold bellows (2) of the pressure parts (1) are well visible

To adjust, use only a ring spanner or a socket.

6

Install on the reverse order

Documente menționate