ar4020b010002a

Checking and adjusting straight-ahead position of front wheels

Tip ar · temă 40.20 · versiune 0201 · 2019-02-15

Valabil pentru: Model 368 Model 382.15/17/18, 384.06/07 Model 634.0

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 40 Roţi, geometria sistemului de rulare › 40.20 Geometria sistemului de rulare — Seria 368 · Seria 382 (modele 15*, 17*, 18*) · Seria 384 (modele 06*, 07*) · Seria 634 (modele 0**)

EinPAS 20 Sistem de rulare › 20.10 Geometria sistemului de rulare › 20.10.20 Diagnoză/Verificare/Măsurare/Reglare — Seria 368 · Seria 382 (modele 15*, 17*, 18*) · Seria 384 (modele 06*, 07*) · Seria 634 (modele 0**)

AR40.20-B-0100-02A

Checking and adjusting straight-ahead position of front wheels

Model

368

Model

382.15/17/18, 384.06/07

Model

634.0

Checking and adjusting straight-ahead position of front wheels

Represented on axle 634.081

1

Positioning the projectors (5) on the projector bracket (4) of the 1st front axle


The vehicle should be in a straight steering line and supported with the front wheels on turntables.



2

Support two measuring stands (2) on the left and right of the 1st rear axle and align them perpendicularly to the vehicle



3

Direct the LH projector's light beam (5) to the scale of the LH measuring trestle (2)


Write down the indicated value
For example: 28.



4

Direct the RH projector's light beam (5) to the scale of the RH measuring trestle (2)


Again, write down the indicated value
For example: 24.



5

Turn the steering wheel until both scales of the measurement stands (2) indicate the same values ​​(mean value)


For example, in this case, the mean value is: 26.


Vehicles with two front shafts with steering:

The straight-line position test on the 2nd front axle should be run in the same manner as with the 1st front axle.


B40.20-0011-03