ar3530t045908c

Pressing propeller shaft flange onto drive pinion

Tip ar · temă 35.30 · versiune 0102 · 2005-07-12

Valabil pentru: MODEL 613.364 /365 mit Hinterachse HOSE für O560'

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 35 Punte spate › 35.30 Impuls, arbore de antrenare — Seria 613 (modele 364, 365)

EinPAS 17 Grup motopropulsor/Punte › 17.51 Punte spate › 17.51.65 Diferențial spate/ax transmisie principală — Seria 613 (modele 364, 365)

AR35.30-T-0459-08C

Pressing propeller shaft flange onto drive pinion

Crown wheel and pinion with differential

Number

Designation

Model 613.364/365
with HOSE rear axle

BA35.30-N-1003-03I

Slotted nut, coupling flange to drive pinion

Nm

1200

Pressing propeller shaft flange onto drive pinion
Pressing propeller shaft flange onto drive pinion

717 589 00 31 00

Retainer wrench

Ratio wrench

000 589 78 63 00

Pressing propeller shaft flange onto drive pinion

T35.30-0046-01

1 Place bolts in propeller shaft flange.

2 Press guard plate (4) onto the propeller shaft flange up to the stop.

3 Place propeller shaft flange, washer and slotted nut on drive pinion gear shaft.

4 Fit retainer wrench (1) to propeller shaft flange.

5 Fit ratio wrench (2) with slotted nut bit (3) on slotted nut of propeller shaft flange.

6 Tighten slotted nut to specified tightening torque .

7 Remove retainer wrench (1) from propeller shaft flange.

8 Secure slotted nut with locking plate.