AR33.25-B-0500C | Inspect steering knuckle | 12.02.16 |
Front axle 739.3 with Vehicle 382.1
Front axle 739.3 with Vehicle 634.0## #D
B33.25-0030-01
B33.25-0027-01
A Ø inner bearing seat
B Ø outer bearing seat
C Axle sleeve length
1 Axle sleeve
2 Dial indicator
3 Dial indicator gauge holder
| Check | ||
| Danger, it is not allowed straightening or aligning the axle sleeve | ||
1 | Visually check the axle sleeve for damage, cracks and wear of bearing seats | If evidence of cracks and excessive wear of bearing seats are found, replace the axle sleeve. | |
2 | Measure axle sleeve | If dimensions extend beyond tolerance, replace axle sleeve. | |
3 | Accommodate the axle sleeve by means of its centering bores, in between the ends, and check the eccentricity of bearing seats | ||
| |||
| |||
If tolerances are exceeded, replace axle sleeve. |
Steering knuckle
Número | Denominação | Front axle: 739.302/330, 739.386/396 | Front axle 739.395/397, 739.398 | |||
BE33.25-B-1001-01A | Shaft end | Measurement A | mm | 69.981...70.000 | 69.981...70.000 | |
Measurement A1 | mm | - | - | |||
Measurement B | mm | 49.975...49.991 | 49.975...49.991 | |||
Measurement C | mm | 202.0...202.3 | 202.0...202.3 | |||
BE33.25-B-1002-01A | Maximum allowed eccentricity between the shaft end bearing seats | mm | 0.04 | 0.04 | ||
363 589 02 21 00
Dial gauge holder
001 589 53 21 00
Indicator