ar3320p0425tx

Checking supporting joint and follower joint of steering knuckle mount (removed)

Tip ar · temă 33.20 · versiune 0102 · 2005-11-08

Valabil pentru: MODEL 219

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 33 Punte faţă › 33.20 Sistem de ghidare a roţii, butuc — Seria 219

EinPAS 17 Grup motopropulsor/Punte › 17.50 Punte faţă › 17.50.42 Fuzetă/Butuc roată/Rulment roată — Seria 219

AR33.20-P-0425TX

Checking supporting joint and follower joint of steering knuckle mount (removed)

26.10.05

MODEL 219

Checking supporting joint and follower joint of steering knuckle mount (removed)
Checking supporting joint and follower joint of steering knuckle mount (removed)

P33.20-2134-02

7f Supporting joint rubber boot

8f Follower joint rubber boot

P33.20-2133-02

Checking

1

Move the ball pin in all directions with an approximately 150 mm long pipe

The ball stud should move without play and without seizing, and should not cause any creaking noise.

2

Check rubber boot (7f) on supporting joint for cracks and damage

Replace supporting joint if necessary.

3

Check rubber boot (8f) on follower joint for cracks and damage

If necessary, replace follower joint:

Remove/install follower joint of steering knuckle bearing.

AR33.20-P-0427TX

Documente menționate