Inspection and adjustment data: splitter unit (splitter group)
Number | Designation | Transmission | Transmissions 715.351/361 | ||
BE26.35-N-1002-01KL | Adjustment dimension for splitter box shift cylinder | mm | 0.4...0.5 | 0.4...0.5 | |
000 589 34 33 00
Counter stay
Internal puller
000 589 30 33 00
W26.35-1006-12
1 Install cylindrical actuator (1) without sealing rings (3).
2 Fit shift cylinder (1) on shift piston (2).
3 Measure dimension (A) from end face of front section of transmission housing to end face of shift cylinder (1).
W26.35-1005-12
4 Install circlip (4).
5 Using internal extractor and counter stay, pull out shift cylinder (1) until circlip (4) makes contact with outer surface of radial groove.
6 Measure dimension (B) from end face of front section of transmission housing to end face of shift cylinder (1).
7 Remove circlip (4).
8 Remove shift cylinder (1) and then detach internal extractor and counter stay from shift cylinder (1).
9 Determine thickness of shim to be installed.
The thickness of the shim to be installed must be the difference between the two measured dimensions (A, B) plus the adjustment value specified in the table:
Thickness of shim = Dimension (A) Dimension (B) + Adjustment value