718 589 00 61 00
transmission removal device
G26.10-3248-78
Shown with removed transmission |
1 | Pit lift | 2.2 | Tensioning strap | |
2 | Transmission removal fixture | 2.3 | Tensioning strap | |
2.1 | Plate | 3 | Wooden block |
G26.10-3249-78
Shown with removed transmission |
1 | Pit lift | 2.4 | Clamping lever | |
2 | Transmission removal fixture | 2.5 | Clamping lever | |
2.1 | Plate | 3 | Wooden block | |
2.2 | Tensioning strap | 4 | Gear cylinder | |
2.3 | Tensioning strap |
1 | Attach transmission removal fixture (2) to pit jack (1). |
2 | Using pit jack (1), raise transmission removal fixture (2) until it is at a distance of approx. 1 cm to underside of transmission. |
The column on the inspection pit lift (1) must be positioned to match the load distribution in the center of the transmission. |
3 | Adjust plate (2.1) on transmission removal fixture (2) using bolts parallel to the transmission's incline angle. |
4 | Place wooden blocks (3) between transmission and plate (2.1). |
5 | Using pit jack (1), raise transmission removal fixture (2) until blocks of wood (3) make contact with transmission. |
6 | Attach tensioning straps (2.2 and 2.3) to transmission housing. |
Position the tensioning straps (2.2 and 2.3), as shown, under the electrical lines, compressed air lines or lever. |
Attach tensioning strap (2.2) between gear cylinder (4) and transmission housing. |
7 | Fasten tensioning straps (2.2 and 2.3) through each clamping lever (2.4 and 2.5). |