ap4210t4253b

Check brake lining thickness

Tip ap · temă 42.10 · versiune 0106 · 2008-01-11

Valabil pentru: MODEL NMB613.355 /455 /485 MODEL NMB613.358 /388 with disk brake PAN 22.5

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 42 Sistem hidraulic frâne şi sistem mecanic › 42.10 Frână de serviciu — Seria 613 (modele 355, 358, 388, 455, 485)

EinPAS 21 Frâne/instalație vacuum/instalație de aer comprimat › 21.15 Frână de serviciu/instalație vacuum › 21.15.40 Frână de serviciu față — Seria 613 (modele 355, 358, 388, 455, 485)

EinPAS 21 Frâne/instalație vacuum/instalație de aer comprimat › 21.15 Frână de serviciu/instalație vacuum › 21.15.42 Frână de serviciu spate — Seria 613 (modele 355, 358, 388, 455, 485)

AP42.10-T-4253B

Check brake lining thickness

1.7.04

MODEL NMB613.355 /455 /485

MODEL NMB613.358 /388
with disk brake PAN 22.5

Check brake lining thickness

T42.10-0008-11

1 Check pin

2 Surface on guide bearing eye

A Distance

	Check
1	Determine distance (A)	 The distance (A) is the distance measured between the end face of the check pin (1) and the machined surface on the guide bearing eye (2). It corresponds to the residual thickness of the brake pad.	*BE42.10-N-1001-11C
		 This indirect test is only a coarse check. When the dimension (A) approaches the service limit, a direct measurement by removing the wheels is possible for reasons relating to safety and tolerances: 
		Remove wheels as a separate repair order	AR40.10-T-1100B
2	Record determined brake lining thickness of the individual wheel brakes in the work log and maintenance sheet.

Test specifications for brake caliper brake pad

Number	Designation			Model 613.355/ 364/ 365/ 455/ 485	Model 613.358/388


BE42.10-N-1001-11C	Brake pad thickness (carrier plate and brake lining)	Normal	mm	28.0	28.0
			mm	10.0	10.0
		Over-dimension	mm	30.0	30.0
			mm	12.0	12.0

Documente menționate

ar4010t1100b