P88.30-2261-07
1 Rear-end door
2 Rear spoiler
3 Nuts
6 Electrical connector
E21 Center high-mounted stop lamp
4 Washer fluid hose
5 Hose connector
| Remove/install | ||
1 | Mask roof edge over entire length along rear spoiler (2). | ||
2 | Open rear-end door (1) | ||
3 | Unscrew nuts (3) | ||
4 | Unclip rear spoiler (2) with snap-release tool | Carefully unclip rear spoiler (2) to prevent damaging paint. | |
Installation: Check retaining clamps on rear spoiler (2), replace if necessary. | |||
| |||
5 | Separate washer fluid hose (4) from hose coupling (5) | ||
6 | Disconnect electrical connector (6) from center high-mounted stop lamp (E21) | ||
7 | Remove rear spoiler (2) | The BRABUS rear spoiler installed on 454.034 or on vehicles with code (E79) smart BRABUS rear spoiler (DFO), cannot be removed from the rear spoiler (2); it must also be replaced when replacing the rear spoiler (2). | |
8.1 | Remove center high-mounted stop lamp (E21) and spraying nozzle on windshield washer system. | When replacing rear spoiler (2). | |
9 | Install in the reverse sequence | ||
10 | Check center high-mounted stop lamp (E21) and spray nozzle for proper function. | ||
11.1 | Check that BRABUS rear spoiler fits precisely and then paint | On model 454.034 or when replacing rear spoiler (2) on vehicles with code (E79) smart BRABUS rear spoiler (DFO) | |
12.1 | Glue on BRABUS rear spoiler | On model 454.034 or when replacing rear spoiler (2) on vehicles with code (E79) smart BRABUS rear spoiler (DFO) |
452 589 01 63 00
Snap-release tool