P88.20-2713-08
1 Expanding rivets
2 Bolts
3 Bolts
7 Rear bumper
P88.20-2714-08
4 Trim Panels
5 Bolts
P88.20-2715-06
6 Grommet
X35/28 PTS, rear bumper connector
Modification notes
| Remove/install | ||
1 | Remove expansion rivets (1) and detach fender liner in area of rear bumper (7). | Do not remove wheels. | |
2 | Remove bolts (2) from both rear fenders | ||
3 | Remove bolt (3) | ||
4 | Open liftgate | ||
5 | Open paneling (4) in load compartment and remove | ||
6 | Remove bolts (5) | Installation: Adjust gap between rear-end door and rear bumper (7) and tighten bolts (5). | |
See: | |||
Gap dimensions on hoods, doors and lids | |||
Gap between rear-end door and bumper "Dimension Z" | |||
Feeler gauge | |||
7 | Remove grommet (6) from body and disconnect rear bumper PTS connector (X35/28) and/or blind spot assist connector | Vehicles with code (220) Parktronic system. Vehicles with code (234) Blind spot assist. | |
Helper required for holding rear bumper (7). | |||
8 | Remove rear bumper (7) toward rear | Use aid of helper. | |
9 | Install in the reverse order |
Test and adjustment values for gap dimensions
Number | Designation | Model 251 | |||
BE60.00-P-1005-01S | Gap dimension | Taillamp to bumper | Dimension "U" | mm | 3.5 (1.5) |
Taillamp to side wall | Dimension "V" | mm | 3.5 (1) | ||
Dimension "W" | mm | 4 (1) | |||
Taillamp to rear-end door | Dimension "X" | mm | 4.5 (1.5) | ||
Rear-end door to antenna module | Dimension "Y" | mm | 5.5 (0.5) | ||
Rear-end door to bumper | Dimension "Z" | mm | 6 (1.5) | ||
See picture | - | ||||
Feeler gauge
129 589 03 21 00