AR77.21-P-0530RT | Remove/install front panoramic glass roof rubber bellows | 10.5.05 |
MODEL 251 with CODE (413) Panoramic glass roof with top sliding roof
P77.21-2062-06
Shown on rubber bellows on left side of vehicle
1 Rubber bellows
2 Rubber bellows bearing
P77.21-2063-06
Shown on rubber bellows on left side of vehicle
1 Rubber bellows
2 Rubber bellows bearing
3 Panoramic roof drive
4 Front glass roof
5 Rubber bellows rail
| Remove/install | ||
Danger! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Open front glass roof | See Operator's Manual | |
Roller sun blind retracted at front. | |||
2 | Carefully detach rubber bellows (1) from panoramic roof drive (3) over entire length in area B with mounting wedge | Do not bend rubber bellows. | |
Installation: Uniformly press rubber bellows onto stay on panoramic roof drive.Do not bend rubber bellows. | |||
Mounting wedge | |||
3 | Slide rubber bellows bearing (2) toward front and unclip (arrow D) | Installation: Rubber bellows bearing should arrest audibly when sliding back. | |
4 | Remove rubber bellows (1) from rubber bellows rail (5) installed on front glass roof (4) (arrow C) | Installation: Position rubber bellows with guide (arrow A) on rubber bellows rail (5) and slightly slide toward rear. | |
5 | Remove rubber bellows (1) together with rubber bellows bearing (2) | ||
6 | Remove rubber bellows (1) from rubber bellows bearing (2) | ||
7 | Install in the reverse order |
Mounting wedge
110 589 03 59 00
Documentos referenciados
- as0000z001101a Risco de lesão ao esmagar ou prender os dedos ao remover, instalar e em trabalhos de regulagem nas capotas, portas, tampas e no teto corrediço