Remove/install panoramic roof water repellent

AR77.21-P-0050RT

Remove/install panoramic roof water repellent

9.5.05



Remove

Danger!

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.

Deburr repair panels.

AS00.00-Z-0017-01A

1

Unclip panoramic roof water repellent (2) from rear toward front with mounting wedge from clips (10) installed in area B.

 Glass roof should be closed at front.Carefully pull panoramic roof water repellent upward when removing clips (arrow A)

 Do not damage paint and components!

 Mounting wedge

*110589035900



Install

2

Check whether clips (10) in area B are in proper state.

 7 each.

 If necessary, replace defective clips.

3

Check whether cover springs (arrows) are properly fastened and in good condition.

 4 in total.

 If necessary, replace panoramic roof water repellent

4

Position panoramic roof water repellent (2) press into clips (10) in area B from front toward rear.

 Ensure that panoramic roof water repellent is firmly arrested in clips!

 Observe gap to front glass roof (1), to rear glass roof (6), to A and B-pillar outer paneling (3), to outer side wall (8), to glass cover (8) and to antenna module cover.If necessary, remove panoramic roof water repellent (2) again and loosen nuts (9) in area B, then align clips (10) again.Use OSR kit for alignment of clips

 Nut, clip on panoramic roof water repellent to panoramic roof frame

*BA77.21-P-1004-01C

Number

Designation

Model 251

BA77.21-P-1004-01C

Nut, clip on panoramic roof water repellent to panoramic roof frame

Nm

2