ar6830s470001s

Remove/install upper paneling on B-pillar

Tipo ar · tema 68.30 · versão 0108 · 2012-04-18

Válido para: MODEL 636, 639

Não disponível em “pt”; apresentado em Inglês.

Onde se situa

Grupo funcional 3 Carroçaria › 68 Acabamento interno › 68.30 Revestimentos, frisos — Série 636 · Série 639

EinPAS 37 Acabamento interno › 37.45 Revestimento › 37.45.30 Revestimento do compartimento interno do veículo/salão dos passageiros — Série 636 · Série 639

AR68.30-S-4700-01S

Remove/install upper paneling on B-pillar

Danger!

Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units.

Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.

AS91.00-Z-0001-01A

Seat belts/emergency tensioning retractors, front seats

Number

Designation

Model
639 without code S23, SH4,
Model
636

Model
639 with code
S23, SH4

BA91.40-N-1002-03A

Bolt, seat belt guide bracket to seat belt height adjustment

Nm

30

30

Remove/install upper paneling on B-pillar

Long wedge

115 589 03 59 00

Remove/install upper paneling on B-pillar

N68.30-2122-06

Shown on model 639.8 on left side of vehicle without code (T19) Left sliding door

1 Cover

2 Cover

3 Wardrobe hook

4 Cover

5 Seat belt guide bracket

6 Screw

1 Remove wardrobe hook (3) on left paneling (1).

Only on model 639.6 with code (VA6) Full side wall paneling and without code (T19) Left sliding door, on model 639.6 with code (V23) Interior trim of superior quality and without code (T19) Left sliding door, on model 639.7/8, 636 without code (T19) Left sliding door.

The mounting screw is located below the cover (2).

2 Remove lower curtain rail on left paneling (1).

Only on model 639.71 with code (VB2) Sightproofing all-round, buttonable (Westfalia) and without code (T19) Left sliding door, model 639.813 with code (ZK7) "Marco Polo" camper.

For this purpose remove stopper, move curtain and unscrew bolt.

3 Remove cover (4) from seat belt guide bracket (5).

4 Remove bolt (6) .

5 Remove paneling (1) with long wedge at bottom.

6 Disconnect electrical connector from push button on electric sliding door.

Only with code (T55) Electrical actuation for right sliding door, with code (T56) Electrical actuation for left sliding door.

7 Remove paneling (1) downward.

Installation: Check mounting clamps, replace if necessary.

8 Install in the reverse order.

9 Check belt height actuation and seat belt for proper function and easy motion.

Documentos referenciados