AR41.10-P-0085-09RT | Measure the absolute angle at the flange of the transfer case | ||
| Data Sheet for Measuring Inclination Angle, Form |
Workshop equipment
WE58.40-Z-1002-15A | Electronic clinometer |
WE58.40-Z-1003-15A | Electronic propeller shaft inclinometer |
WE58.40-Z-1004-15A | Electronic combination measuring instrument |
P41.10-2269-09
3a Absolute angle at front flange of transfer case
3b Absolute angle at rear flange of transfer case
P41.10-2289-09
Measurement of absolute angle 3a at front flange of transfer case
086a Sensor
8a Adapter for transmission
10 Cable
12 Front flange on transfer case
1 Attach the adapter for transmission (8a) to the front flange on the transfer case (12) and move into the horizontal position using the spirit level.
The absolute angle at the front flange of the transfer case (3a) and the absolute angle at the rear flange of the transfer case (3b) have the same value. The absolute angle at the front flange of the transfer case (3a) is measured here.
Check seat of the magnetic fork at the front flange on the transfer case (12).
If the position of the sensor (086a) deviates too much from the horizontal, a fault message appears on the measuring instrument display, no value can be read off or stored.
2 Place the sensor (086a) on the support plate.
-----------------------------------------------------------------------------------------
The cable (10) must point in the direction of travel (arrow), otherwise an incorrect measurement will occur.
Ensure that the sensor (086a) is seated correctly in the bores of the support plate, otherwise an incorrect measurement will occur.
3.1 Read off absolute angle at the front flange of the transfer case (3) on the measuring instrument display and enter in the data sheet.
If the electronic inclinometer is used or if measurements are made in inclination measuring mode with the electronic articulation/propeller shaft inclinometer
The X-value must be read off on the display. Otherwise incorrect measurement results occur.
The measured value must not be stored.
-----------------------------------------------------------------------------------------
The absolute angle at the front flange of the transfer case (3) may only be read off if the sensor (086a) is on standby and the displayed value is constant.
3.2 Store the absolute angle at the front flange of the transfer case (3) in the measuring instrument.
If the electronic propeller shaft inclinometer with memory extension or the electronic articulation/propeller shaft inclinometer with memory extension is used in articulation angle measuring mode.
Save the measured value by pressing the SAVE button. After this the measurement readiness for the fourth angle is displayed.
The absolute angle at the front flange of the transfer case (3) may only be stored if the sensor (086a) is on standby and the displayed value is constant.