AR35.31-P-0550-28E | Attaching end cover | ||
| Rear axle center assembly end cover with non-machined sealing surface | Rear axle center assembly dia. 210 mm with rear axle center assembly 210E as of 15.05.00 |
Rear axle center assembly housing
Number | Designation | Model | Model | |||
BA35.31-P-1001-02A | Bolt, end cover to rear axle differential | Bolt+washer | Nm | - | 50 | |
Flange bolt | Stage 1 | Nm | 30 | 30 | ||
Stage 2 | ° | 45 | 45 | |||
Rear axle center assembly housing
Number | Designation | Model | Model | |||
BA35.31-P-1001-02A | Bolt, end cover to rear axle differential | Bolt+washer | Nm | - | - | |
Flange bolt | Stage 1 | Nm | 30 | 30 | ||
Stage 2 | ° | 45 | 45 | |||
Torque wrench
001 589 66 21 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1010-01A | Hylomar universal sealant 80 ml | A 001 989 25 20 |
P35.31-2040-10
Use new bolts.
1 Clean the sealing surface on the end cover (54) and rear axle center assembly housing and then coat with sealing compound
2 Fit end cover (54).
Rear axle center assembly with bolts with captive washers
3.1 Mount combination bolts and tighten using torque wrench .
Shown on rear axle center assembly with flange bolts
Rear axle center assembly with flange bolts
3.2 Tighten the flange bolts with torque wrench to stage 1 .
4.1 Mark bolt flanges relative to rear axle differential housing (a).
5.1 Put markings (b) on rear axle center assembly housing offset by 45°.
6.1 Tighten flange bolts with 45° tightening angle as per stage 2.
The markings (a, b) should coincide The tightening angle can also be checked using a commercially available angle tester.